C2000ware 5.02 地址变量为：COM_TI_C2000WARE_INSTALL_DIR，CCS12.2以上版本能够直接匹配识别！ 但是C2000ware4.03版本地址变量为：COM_TI ...

I have a question about VC and CB pins. I know I can use GPIO3 - GPIO11 as NTC / Analog input / Digital control, however, can I use either VC or CB pin for NTC? For example, battery cells are ...

I am using OrCAD X Capture 23.1 (trial version), and the PSpice for TI is installed on my computer at the same time. Errors about netlisting errors appear, as following: INFO(ORNET-1041): Writing ...

3. Output current capability > 1.1A (application scenario: at 25°C, the TEC internal resistance is 1.229Ω~1.502Ω); 4. It is best to support NTC detection function.

During the process of adding a new driver in TDA4 VM, we found that there was an interrupt when reading or writing to the sensor register address 0xffff, which means that the subsequent sensor ...

I'm using the DAC82002 and am interested in achieving the maximum update rate possible. It appears to be only ~780 ksps (or maybe 500 ksps) per channel rather than 1 Msps and I want to confirm. Per ...

I see this message when I try to select an I2C channel other than I2C_6, I cannot identify the cause of this problem, the PINs that I want to configure are free. Attached is the project that I am ...

I am using an ADS131A02 and an ESP32-PICO-KIT for my project. In this case, the ADS131A02 is in synchronous slave interface mode, as I will be using SCLK as iCLK. The problem is that I cannot get a ...

The two technologies are not compatible. Is there any reason an FPDlink SER cannot be used? I can provided compatible device to the ADI MAX96724/F/R.

I would like to calculate the accuracy error of the ADS8678IDBT. The calculation method we are currently considering is as follows, but we would like you to check if ...

Please see the attached one it can't start the sim,and seem still can't sim 0V when AC1 touch the ground(0V) ...

We will need an NDA to share an advance datasheet, please work through your local sales rep to obtain datasheet, with NDA. if there is a specific specification you are interested in, please let us ...